Partner Dashboard: Refreshing the Partners Alert page will fail to load if a customer is loaded in another tab. The alert can be acknowledged when its identified as related to this known issue. If this is related to this known issue, you will not see an extra banner, and your sync is normal/successful. If this was a legitimate error, you will see a banner with the same message stating API permissions are missing, and the sync would fail. What to do if you receive this alert: go to your Global Settings > Directory Services > select your Azure AD sync service in question. While the timeout is temporary, it is incorrectly triggering this alert to be sent. This alert is incorrectly be triggered due to a timeout with the Azure AD sync. Some customers may see an alert in the dashboard showing the message: “Microsoft API permissions are missing." Even when the permissions are correctly configured. The 192.168.1.Central Dashboard: Medium Alert that states The Graph Api permissions are missing. TX packets:536 errors:0 dropped:0 overruns:0 carrier:0 RX packets:536 errors:0 dropped:0 overruns:0 frame:0 TX packets:75821 errors:0 dropped:0 overruns:0 carrier:0 RX packets:9214 errors:0 dropped:0 overruns:0 frame:0 TX packets:2879 errors:0 dropped:0 overruns:0 carrier:0 RX packets:75708 errors:0 dropped:0 overruns:0 frame:0 TX packets:2375 errors:0 dropped:0 overruns:0 carrier:0 RX packets:3191 errors:0 dropped:0 overruns:0 frame:0 TX packets:161 errors:0 dropped:0 overruns:0 carrier:0 RX packets:290 errors:0 dropped:0 overruns:0 frame:0 UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 However the iOS device which connected to the WIFI network (my real router) configured to use the VM gateway has no internet connection. The host machine hosting the VM can ssh into the VM and has a ping to the VM and to the real routerĪll is fine until I change my iOS device to manual and provide it with a static IP and the router VM as the gateway and DNS address The "router" is working fine, it has internet connectivity and can ping the real router in my office (192.168.1.1) The last interface on eth2 is optional according to the guide and made no difference. My /etc/config/network config interface 'loopback' I followed the guide here dozen of times:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |